Rotate the elevation knob forward until the sight is all the way down. You may be able to Right Click and Save-As.ġ. Try page 97 (Adobe page) of this document. I've spoken to someone else at my local range and he said the same thing. I've also found that shooting 50 gives an approximate 100 yd zero (shooting surplus port ammo). If all you have is 50 yards, setting your elevation wheel to "1" after sighting in will get you pretty close in calibration out to at least 200 yards, at least until you can test group it well at 100 or 200 yards and further refine your zero. I still need to shoot some careful 200 yard groups, and maybe readjust the elevation wheel a click or two. But I was shooting soap jugs, not apples. The only elevation change I had dialed in was from "1" to "2". Then when I went to shoot laundry soap jugs at 200 yards, I hit the first jug in 2 shots. I know, I know, the "manual" says do it differently. The rear sight was bottomed out, and I adjusted the elevation wheel so the "1" was set next to the index mark on the receiver. How you hold on the bull probably matters, but when I was rezeroing the irons on my SA Scout recently, it seemed that when I was "dead on"(poa = poi) at 50 yards, I was also dead on at 100 yards, using Aussie F4 ball. What if your only choices are 50 and 100 yards?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |